Sony DCR-TRV8 Operating Instructions Manual page 159

Hint
If a message box appears indicating a communications problem, refer to steps 6 and 7
Connections and Settings, and perform the following steps:
• Decrease the baud rate.
• Confirm that the port settings are correct.
Note
If an image has been read and any of the following actions taken, repeat the procedur
from step 1.
- Power to the MS Serial Port Adapter has been turned off and back on,
- The cable has been disconnected.
- The Memory Stick was removed."
Notes
• After working with an image after viewing the List View, such as Single-Jmage
viewing, some time will be required to re-read the images.
• As the MS Serial Port Adapter and PC are busy commianicating until all image are
read, do not disconnect the cable during this period.
• If an error occurs, disconnect and then reconnect the PC serial Cable at the MS Seri.
Port Adaptor side.