Routing And Connecting The Wiring Harness Onto The Backhoe - Toro RT600 Operator's Manual

10
Routing and Connecting the
Wiring Harness onto the
Backhoe
No Parts Required
Procedure
1. Remove the 4 bolts and 4 washers that secure the
controls cover to the operator pedestal of the backhoe,
and remove the cover
Figure 26
1. Operator pedestal
2. Controls cover
2. Route the backhoe harness upward and along the
2 leftmost hydraulic hoses at the back plate of the
backhoe (Figure 27).
(Figure 26).
3. Washer
4. Bolt
1. Backhoe wiring harness
2. Forward
3. Two-socket connector
4. Seat-post tube
3. Route the harness upward and between the left and
right console-support plates of the operator pedestal
(Figure 27).
4. Route the branch of the harness with a 2-socket
connector through the tube of the seat post
5. Connect the 2-socket connector of the backhoe wiring
harness to the 2-pin connector of the operator presence
switch (Figure 28).
Note: Ensure that there is enough slack in the branch
of the harness for the operator-presence switch at the
forward end of the seat post.
1. Operator-presence switch
20
Figure 27
5. Console-support plate
(left)
6. Console-support plate
(right)
7. Hydraulic hoses
8. Hydraulic-bulkhead plate
(Figure
Figure 28
2. Two-pin connector,
backhoe wiring harness
27).