Advertisement
(2) Paper guide F location
Move the paper guide F all the way up (standard position).
Adjust the paper guide F location when paper creasing or
misfeed is encountered.
Loosen
(3) How to remove the separator pawl
@) Remove the fusing cover B.
\ /
Separator paw!
Clips
(4) How to remove the heater lamp —
@
Remove the heater lamp harness connector located on
the rear frame side.
@) Remove the heater lamp harness connector located on
the front frame side.
SF-7200
6) Remove
the lamp holders on both the front and rear
frame sides, and remove the heater lamp from the front
frame side.
Heater lamp
e
Lamp holder
TENG
Remove
(5) Installation of thermistor and thermal fuse
Thermistor
The thermistor must be in contact with to the fusing roller.
The surface of the thermistor must be clean. If it is dirty,
wipe it clean with alcohol.
Must be in contact
Upper heat roller
Thermal fuse
The gap between the thermal fuse and the heat roller must
be 1+0.2mm.
140.2mm
Upper heat roller
Thermal fuse
(6) How to remove fusing roller, fusing roller
frames, L and R (bushing)
@
Remove the fusing covers, A and B.
(2) Remove the thermistor/thermal fuse holding bracket.
Remove
Thermistor/thermal fuse
holding bracket
Remove
10-3
1¢
Advertisement
