Technics SX-KN200 Manual page 34

TM—--OZzm
28
Symptoms which appear to be
signs of trouble
The following changes in performance may occur in the Technics Keyboard but do not indicate trouble:
Phenomenon
Remedy
m Sounds and effects
The buttons, keys, etc. malfunction.
KN200
Turn off the PLAY button once, then turn it on again. All
settings return to their factory-preset (initialized) status.
KN400
Turn off the POWER button once. Then, while pressing all
three MANUAL PERCUSSION buttons, press the POWER
button to turn it on. All settings return to their factory-
preset (initialized) status.
No sound is produced when the keys
are pressed.
The MAIN VOLUME is at the minimum setting. Adjust the
volume with the MAIN VOLUME control.
The DEMO ) button is on, and ——— (KN200) or ——-—
(KN400) is shown on the display. Press the DEMO J but-
ton to turn it off. The display returns to the tempo display.
(Refer to Vol. 1, page 10.)
The BALANCE volumes are set to 0.
KN200: Press the POLY (+) button in the BALANCE section
to adjust the volume. (Refer to Vol. 2, page 5.)
KN400: Press the + buttons for POLY 1, POLY 2 and BASS
& ACCOMP to adjust the volumes. (Refer to Vol. 2, page 5.)
The local control for a part performed on the keyboard is
set to off. Set the local control to on. (Refer to Vol. 3,
page 32.)
When many keys are pressed at the
same time, not all of them sound.
Up to 11 notes can be produced simultaneously. The num-
ber of notes which can be produced simultaneously may
decrease depending on the selected sound, the DIGITAL
CELESTE status, the ACCOMP PART status (KN400), etc.
When the DIGITAL CELESTE is on
and you change the sound, the DIGI-
TAL CELESTE turns off.
KN400: The DIGITAL CELESTE effect does not function
for DUAL, DUET and TRIO mode sounds. (Refer to the
Reference Guide.)
CONDUCTOR, AUTO PLAY CHORD
and PANEL MEMORY do not work.
The MIDI receive mode is set to the multi mode. Set the
receive mode to the single mode. (Refer to Vol. 3, page
32.)
The highest note of the SOLID
GUITAR sound is strange.
This is not a malfunction. When the SOLID GUITAR
sound (VARIATION on) is assigned to the POLY part
(KN200) or POLY 1 or 2 part (KN400), or when the SPE-
CIAL 6 sound is assigned to the ACCOMP PART, the
highest played note for that part becomes a cutting sound.