Table of Contents
Advertisement
PARKING
MACHINE ROLL AWAY can cause injury or death.
ALWAYS engage Parking Brake when leaving unit
unattended.
Stop engine and remove key before cleaning or
servicing unit.
To park, stop the unit and engage the Parking Brake.
Always take all possible precautions when leaving unit
unattended.
Mowina Tips
The following tips will help you to mow safely, achieve
maximum performance from you unit and maintain the
desired appearance of your lawn.
NOTE:
Clean mower pan after each use. DO NOT
allow grass clumps or a coating of grass and debris to
collect inside of mower pan. Avoid operation over bare
ground intermittent with grass cutting as this causes
dirt and grass to collect and cake under pan surface.
Grass should be cut when it si dry, not when it is wet
from dew, rain or watering. Wet grass tends to pack
inside mower pan and will not discharge, mulch or bag
properly, especially if height of cut is set too low.
Keep mower blades sharp. Dull blades will tear grass
and a white cast will result over a freshly cut lawn. The
tips of the grass blades will then turn brown.
A new lawn has soft blades of grass and a high
moisture content. It is important to cut a new lawn with
sharp blades.
Proper leveling and pitch of the rotary mower pan is
needed for a smooth even lawn. If the pitch of the
mower pan is reversed or inadequate, grass will be cut
twice, resulting in frayed grass ends. Too much pitch
will cause an uneven cut.
Upon first use of mower, cut the grass at a longer
length than usual. This will prevent scalping due to the
irregularities in the lawn.
To insure the most complete and even cut, overlap
each swath.
Plan your cutting so that you always trim with the left
side of the mower pan.
Following the same pattern each time you mow the
lawn can develope ridges. Change direction in mowing
pattern (when possible) to prevent ridges.
Generally, grass should be cut at about 1-1/2" long in
the spring and not less than 2" long in the hot summer
weather.
Ariense EZRider™
Orig. 1/98
Lower unit speed at turns to prevent scuffing.
If grass is high, or if it contains a high degree of
moisture, cut it first with the mower pan set high. Cut
the grass a second time, with the mower pan set lower,
for a better distribution of clippings and a cleaner cut.
For thick, lush or heavy growth lawns do not set the
cutting height too low. Grass cut too short may die.
When the mower pan is set too low, the mower pan will
drag on the grass and restrict air flow, causing a
reduction in the discharge of grass clippings.
Discharge grass clippings away from borderline objects
(sidewalks, driveways, fences) when cutting grass.
Discharge grass clippings over cut grass when not
cutting borderlines. This will prevent buildup of grass
clippings on uncut areas.
Adjust Anti-Scalp Rollers properly for smooth
appearance in cut (see Adjustments).
Mow with engine set a full throttle to maintain proper
blade speed and air flow for discharge of clippings.
NOTE:
Grass catcher components are subject to wear,
damage and deterioration which could expose moving
parts or allow objects to be thrown. Frequently check
components and replace with manufacturer's
recommended parts when necessary.
Advertisement
Table of Contents
