Table of Contents
Advertisement
Precautions for installation
The wine chiller shall not be tilted over 45° when being handled, and it can be electrified only 120
minutes after handling operation.
The wine chiller must be placed on a flat and solid ground surface. If it needs to be elevated, a
stable, solid and inflammable pad shall be used. Never use the packaging foam as the pad to
elevate the wine chiller.
Do not place the wine chiller in the area exposed to moisture or water splash. The water splash or
dirt on the wine chiller shall be timely removed using the soft cloth to prevent rusting and impairment
of electric insulative.
This wine chiller is designed to operate in environment temperature specified by its climate type
marked on the rating place. Do not use it in the rain. The wine chiller shall be kept far away from the
heat source and protected against sunshine, to avoid influencing the normal operation of the wine
chiller.
The appliance is only applied with power supply of single-phase alternating current of
220~240V/50Hz.The device uses a wall socket earthed according to current recommendations.
If the power cable is damaged, do not proceed with his replacement but contact your after-sales
service.
The socket must be readily accessible but out of reach of children. If unsure, contact your installer.
The wine chiller shall be well ventilated; otherwise, the normal operation of the wine chiller may be
adversely influenced. The ventilated space must be at least 20cm from the both sides of the wine
chiller. The ventilated space must be at least 10cm from the top and back sides of the wine chiller.
Precautions for operation
1.
Clean the wine chiller.
2.
Keep the wine chiller level. After the wine chiller is leveled and cleaned, do not electrify it
immediately. Keep the wine chiller stationary for more than 2 hours, and then electrify it to ensure
the normal operation of the wine chiller.
3.
Close the wine chiller door, and insert the power line. After the power supply is switched on, the
wine chiller will start to work. If the wine chiller fails to work in a long period of time, check whether
the power socket and the electric circuit work normally. If, half an hour later, an abrupt reduction of
temperature is detected after the wine chiller door is opened, the wine chiller works normally. After
2~3 hours, adjust the temperature and then fill wines according the instruction. It is normal the
compressor will work for a longer time for the initial plugging, and then works intermittently.
4.
Generally, do not stop the wine chiller, to avoid influencing its normal service life. After the power
line plug is removed, wait for at least 5 minutes before inserting it again, to ensure the normal
operation of the wine chiller.
5.
Do not switch off the power supply of the wine chiller when unnecessary, because the power
interruption may cause temperature rise inside the wine chiller, thus to shorten the storage term of
wines and degrade their drinking quality.
6.
A certain space shall be maintained between wine bottles, which will facilitate the circulation of cool
air. The figure illustrates the layout of drawers, baskets and shelves that result in the most efficient
use of energy for the refrigerating appliance.
7.
It is not allowed to flush the wine chiller body using water, nor to wipe the body using the gasoline
or other organic solvents.
8.
If the power cord is damaged, it must be replaced by the professional of the manufacturer, its repair
department or any similar department to avoid any danger.
9.
All power sockets must be reliably earthed.
10.
The system shall be set up during the initial operation of the product for better protection of this
product.
7
Advertisement
Table of Contents
