Installation Instructions - Kadeka KA24WR Instruction Manual

 Before Using Your Wine Chiller

Remove the exterior and interior packing.

Before connecting the Wine Chiller to the power source, let it stand upright for approximately
2 hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.

Clean the interior surface with lukewarm water using a soft cloth.

Install the handle on the left side of the door.

When replace the illuminating lamp, please select the lamp which complies with the rated
power input of lamp according to the rating label. Shut off the power supply before replacing
the lamp.

When disposing your appliance, please choose an authorized disposal site.
 Installation of Your Wine Chiller

This appliance is designed to be for free standing installation or built-in (fully recessed).

To ensure adequate ventilation for your Wine Chiller, allow a minimum of 20mm of airspace
on each side of the chiller and 50mm at the rear.

Place your Wine Chiller on a floor that is strong enough to support it when it is fully loaded.
To level your Wine Chiller, adjust the front leveling leg at the bottom of the Wine Chiller.

Locate the Wine Chiller away from direct sunlight and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the unit not to perform
properly.

Avoid locating the unit in moist areas.

Plug the Wine Chiller into an exclusive, properly installed-grounded wall outlet. Do not under
any circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized service center.

INSTALLATION INSTRUCTIONS

6