Important Safety Instructions; Installation Instructions - Kadeka KSJ168EW Instruction Manual

Hide thumbs Also See for KSJ168EW:

Instruction manual (17 pages)

Table of Contents

WARNING

Read all instructions before using the Wine Chiller.

DANGER or WARNING: Risk of child entrapment.

Child entrapment and suffocation are not problems of the past. Junked or

abandoned appliances are still dangerous . . . even if they will "just sit in the

garage a few days".

Before you throw away your old Wine Chiller: Take off the door. Leave

the shelves in place so that children may not easily climb inside.

Never allow children to operate, play with, or crawl inside the appliance.

Never clean appliance parts with flammable fluids. The fumes can create a

fire hazard or explosion.

Do not store or use gasoline or any other flammable vapors and liquids in

the vicinity of this or any other appliance. The fumes can create a fire hazard

or explosion.

 Before Using Your Wine Chiller

Remove the exterior and interior packing.

Before connecting the Wine Chiller to the power source, let it stand upright for approximately 2

hours. This will reduce the possibility of a malfunction in the cooling system from handling during

transportation.

Clean the interior surface with lukewarm water using a soft cloth.

Install the handle on the left side of the door.

When replace the illuminating lamp, please select the lamp which comply with the rated power

input of lamp according to the rating label. Shut off the power supply before replacing the lamp.

When disposing your appliance, please choose an authorized disposal site.

 Installation of Your Wine Chiller

This appliance is designed to be for free standing installation or built-in (fully recessed).

Place your Wine Chiller on a floor that is strong enough to support it when it is fully loaded. To

level your Wine Chiller, adjust the front leveling leg at the bottom of the Wine Chiller.

Locate the Wine Chiller away from direct sunlight and sources of heat (stove, heater, radiator,

etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical

consumption. Extreme cold ambient temperatures may also cause the unit not to perform properly.

Avoid locating the unit in moist areas.

Plug the Wine Chiller into an exclusive, properly installed-grounded wall outlet. Do not under any

circumstances cut or remove the third (ground) prong from the power cord. Any questions