Advertisement
NAMES AND USES OF PARTS
© MUTING switch
Use to temporarily cut out all audio signals.
When the function is ON, sounds will be cut off. (POW-
ER indicator will flash)
When turned OFF, the sound returns to its previous le-
vel. The muting ON/OFF function can also be operated
by the accessory remote control unit.
@ VOLUME control/indicator
Use to adjust sound volume.
When operated by remote control, this control will rot-
ate with the knob indicator flashing.
Adjustment can also be performed with the accessory
remote contro! unit.
@ GRAPHIC EQUALIZER controls/indicators
These controls can be used to emphasize or de-empha-
size sounds in the frequency bands 60Hz, 150Hz, 400Hz,
TkHz, 2.4kHz, 6kHz, 15kHz, thus allowing you to control
tone quality. The center position of each control is the
normal (flat) setting. When raised above the center posi-
tion, the control frequency band is emphasized; when
lowered, the band is de-emphasized.
@ EQUALIZER ON/OFF switch
When this switch is pressed, the GRAPHIC EQUALIZER
control's indicators turn on, and its functions become
Operative.
When pressed once again, the indicators go out and its
are turned OFF. Use this switch in the following manner:
[ON]
: When
using the equalizer
to add sound com-
pensation
while
performing
program
sources,
and
playing
back
and/or
recording
results.
[OFF]: When
not
using
the
equalizer,
but
playing
back
or
recording
program
sources
without
compensation.
8
<ARB1133>
@ SPECTRUM ANALYZER
This display shows the condition of sound signals compen-
sated with the graphic equalizer controls.
(Because the level indicator is connected to the input side,
the indication does not change when the VOLUME control
is turned.)
@ FUNCTION indicators
These indicators light to show the setting of the FUNC-
TION switches.
@® STANDBY/SLEEP indicator
e
This indicator flashes when
the accessory
remote
contro! unit is used to turn the SLEEP key. When the
SLEEP key is ON, the indicator will flash. (Initially it
will flash slowly, then gradually become faster.)
Sixty minutes after the sleep timer is turned ON, the
power switch will be turned to STANDBY automati-
Cally.
©
This indicator lights when the accessory remote con-
trol unit or this unit is used to turn the POWER key.
This component features a built-in microcomputer which
will recall the last-set positions of the following switches
for up to about several days after the power cord is dis-
connected. As a result, when the power is turned ON
again, the previously set positions will be recalled auto-
matically:
e FUNCTION switch
® MUTING switch
@ EQUALIZER ON/OFF switch
When the unit is not used for more than several days,
the memorized setting positions will be erased, and re-
turned to the following settings:
Advertisement
