Advertisement
OPERATIONS
RECORDING TAPES:
e The sound compensated with the built-in graphic equaliz-
*®
While listening to playback on equipment connected to the
er can be recorded. Set the EQUALIZER ON/OFF switch to
rear panel terminals , you can record these same sounds on
The ON Pe Huon:
ae
;
tape merely by setting your tape deck to the recording
e
Refer to the operating instructions for your tape deck for
mode.
proper operating procedures.
PLAYBACK
RECORDING
TO USE THE COMPONENT CONNECTED TO
(2) Remove the two connecting bars from the
THE ADAPTOR TERMINALS:
adaptor terminals.
Connecting the dynamic expander to the adapter makes it
possible to enjoy the dynamic expander's effects. Also, sur-
S
round sound can be enjoyed by connecting a surround pro-
cessing amplifier.
©
acta lie
Connecting
bars
(3) Connect the adaptor component in accor-
dance with the connection diagram in the
section ''Connections."
[Operation]
(1) Playback the source.
(2) Operate the adaptor component.
The sound compensated with the connected adaptor
:
component can be recorded on a tape deck. Signals
[Connection]
modified with an adaptor component can be recorded
(1) Set the POWER switch to OFF.
on a tape deck. However, surround sound from a sur-
round processing amp cannot be recorded.
NOTE:
Be sure to perform this operation with the adaptor component power
Switch in the ON position. Even when not using the adaptor corrpo-
nent, its power switch must be left ON. If the adaptor componert is
switched OFF, no sound will be produced, or the playback sound will
be distorted.
For details, refer to the adaptor component's operating insiruc-
10
tions.
<ARB1133>
Advertisement
