Advertisement
NAMES AND USES OF PARTS
TUNER
@ FM MONO switch/indicator
Normally
this is set to the off position
(the FM
MONO
indicator goes off). When noise spoils the reception of an FM
program, press the switch to the on position (the FM MONO
indicator will now light).
The program of an FM stereo broadcast will be heard in mono.
The setting of the FM MONO switch (on or off) is memorized
along with
the
station
frequency
in the
STATION
CALL
switches.
When using the preset tuning feature, reception will be in the
mode selected when the station was memorized.
This switch will not function for AM reception.
@ AUTO/MANUAL tuning switch/indicator
Use to select either the AUTO
mode or MANUAL
mode
for
FM/AM reception. (When the auto tuning mode is selected, the
AUTO TUNING indicator will now light.)
© STATION CALL switches
These are used to recall preset broadcasting
stations and to
preset the station.
@ MEMORY switch
This switch is used to memorize stations. When the switch is
Pressed, the frequency indicator will flash. To memorize the
frequency
of any station, press the STATION
CALL
switch
while the frequency display is flashing.
16
<ARB1133>
@ FREQUENCY
display
Permits reading of the received frequency at a glance from
the displayed figure. The FM band is indicated by MHz, and
the AM band by kHz.
@ TUNING switch
This is used to locate the stations.
Push either side of this switch; the left side "—" to go toa
lower, and the right side '+" to go to a higher frequency.
@ STEREO indicator
This lights when a stereo program has been picked up during
an FM broadcast.
© TUNED indicator
This lights to indicate when the finest tuning of a station has
been achieved.
© BAND selector switch
Advertisement
