Advertisement
IMPORTANT 1
The lightning flash with arrowhead,
within an equi-
lateral triangle, is intended
to alert the user
of the
presence of uninsulated 'dangerous voltage" within
the
product's
enclosure
that may
be
of sufficient
magnitude to constitute
a risk of electric shock
to
persons.
IMPORTANT 2
If the apparatus is fitted with AC mains power out-
let(s), see REAR
PANEL
FACILITIES
for convenient
connection
of additional
Hi-Fi component(s).
Make
all connections
to the AC
outlet(s}
and the signal
terminals first. Connect
the plug to the wall socket
last, make sure that the power switch is off.
READ
INSTRUCTIONS
—All
the
safety
and
Operating instructions should be read before the
appliance is operated.
RETAIN INSTRUCTIONS
— The operating instruc-
tions should be retained for future reference.
HEED
WARNING
— All warnings on the appliance
and
in the
operating
instructions
should
be
adhered to.
FOLLOW INSTRUCTIONS — Ali operating and use
instructions should be followed.
'WATER AND
MOISTURE
— The appliance should
not be used near water
—
for example,
near a
bathtub, washbowl, kitchen sink, laundry tub, ina
wet basement, or near a swimming pool, etc.
LOCATION —- The appliance should be installed in a
stable location.
WALL
OR CEILING
MOUNTING
— The appliance
should not be mounted to a wall or ceiling.
VENTILATION
— The appliance should be situated
so that its location or position does not interfere
with its proper ventilation. For example, the ap-
pliance should not be situated on a bed, sofa, rug,
or similar surface that may block the ventilation
openings; or, placed in a built-in installation, such
as a bookcase
or cabinet that may
impede the
flow of air through the ventilation openings.
HEAT — The appliance should be situated away from
heat sources
such
as radiators,
heat
registers,
stoves, or other appliances (including amplifiers)
that produce heat.
POWER
SOURCES
—The
appliance
should
be
connected
to a power
supply only of the type
described
in the
operating
instructions
or
as
marked on the appliance.
POWER-CORD
PROTECTION
— Power-supply
cords should be routed so that they are not likely
to be walked on or pinched by items placed upon
or against them,
paying
particular
attention
to
cords at plugs, convenience receptacles, and the
point where they exit from the appliance.
POLARIZATION — If your
purchased
product
is
provided with a polarized power plug, please read
the
following
instructions.
This
product
is
equipped with a polarized alternating current line
plug (a plug having
one
blade wider than the
other). This plug will fit into the power outlet only
one way. This is a safety feature. If you are unable
to insert the plug fully into the outlet, try reversing
the plug. If the plug should still fail to fit, contact
your electrician to replace your obsolete outlet.
Do not defeat the safety purpose of the polarized
plug.
CLEANING — The appliance should be cleaned only
with a polishing cloth or a soft dry cloth. Never
clean with furniture wax, .benzine, insecticides or
other volatile liquids since they may corrode the
cabinet.
2
<ARB1133>
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:
TO PREVENT THE RISK OF ELECTRIC SHOCK,
DO
NOT
REMOVE
COVER
(OR
BACK).
NO
USER-SERVICEABLE
PARTS
INSIDE.
REFER
SERVICING
TO
QUALIFIED
SERVICE
PERSONNEL.
FOR USE IN THE UNITED
KINGDOM
The wires in this mains lead are coloured
in accor-
dance with the following code:
Blue:
Neutral
Brown:
Live
SAFETY INSTRUCTIONS
POWER
LINES
— An outdoor
antenna
should
be
located away from power lines.
NONUSE
PERIODS —The
power
cord
of
the
appliance should be unplugged from the outlet
when left unused for a long period of time
OBJECT
AND
LIQUID
ENTRY — Care should
be
taken so that objects do not fall and liquids are
not spilled into the enclosure through openings.
DAMAGE REQUIRING SERVICE — The appliance
should be serviced by a Pioneer authorized ser-
vice center or qualified service personne! when:
The
power-supply
cord
or the plug
has
been
damaged; or
Objects have fallen, or liquid has been spilled into
the appliance; or
The appliance has been exposed to rain; or
The appliance does not appear to operate
nor-
mally or exhibits
a marked
change
in perfor-
mance; or
@
The appliance has been dropped; or the enclosure
damaged.
SERVICING — The
user
should
not
attempt
to
service the appliance beyond that described in the
operating
instructions.
For all other
servicing,
contact
the nearest
Pioneer
authorized
service
center
POWER LINES
SERVICE
ENTRANCE
CONDUCTORS
GROUND
GROUND WIRE a.b
4 CLAMPS
,
if
SERVICE ENTRANCE
EQUIPMENT
WIRE
OT gs
Ze»
CLAMPS
7 OPTIONAL ANTE
POWER SERVICE
GROUNDING ELECTRODE SYSTEM
(e.g. intertor metal water pipe)
DRIVEN 8 FEET (
BONDING
JUMPER d
tF REQUIRED BY
LOCAL CODES S'
NEC SECTION 81
STAND-OFF
INSULATORS b
ANTENNA
LEAD-IN WIRE
TO EXTERNAL ANTENNA
TERMINALS OF PRODUCT
The exclamation point within an equilateral triangle is
intended to alert the user of the presence of important
operating and maintenance (servicing) instructions in
the literature accompanying the appliance
As the colours of the wires in the mains jead of this
apparatus
may
not
correspond
with
the
coloured
marking identifying the terminals in your plug proceed
as follows:
The wire which is coloured blue must be connected to
the terminal
which
is marked
with
the letter N or
coloured black.
The wire which is coloured brown must be connected
to the terminal which
is marked
with the letter L or
coloured red.
Equipment sold in the U.K. is not supplied with
a power
plug.
OUTDOOR ANTENNA GROUNDING — If an out-
side antenna
is connected
to the antenna termi-
nal, be sure the antenna system is grounded so as
to provide some protection against voltage surges
and built up static charges.
In the U.S.A.
section
810 of the National
Elec-
trical Code, ANSI/NFPA
No. 70-1984,
provides
information with respect to proper grounding of
the mast and supporting structure, grounding of
the lead-in wire to an antenna discharge unit, size
of grounding
conductors,
location
of antenna-
discharge unit, connection
to grounding elec-
trodes, and requirements for the grounding elec-
trode. See Fig. A.
Use No. 10 AWG
(5.3 mm?
cop-
per, No.
8 AWG
(8.4 mm*)
alu-
minum,
No. 17 AWG
(1.0 mm?)
copperciad steel, bronze wire, or
larger as ground wire
Secure
antenna
lead-in
and
ground
wires
to
house
with
stand-off insulators spaced from
4 feet
(1.22
meters)
to 6 feet
(1.83 meters) apart
Mount antenna discharge unit as
closely as possible to where lead-
in enters house.
Use jumper wire not smaller than
No.6 AWG
(13.3 mm?) copper,
or the equivalent,
when
a sepa-
rate antenna-grounding electrode
is used.
See NEC Section 810-21
(j).
ANTENNA
DISCHARGE UNIT c
GROUND
a,b
NNA
GROUNDING ELECTRODE
2.44 m)
INTO THE EARTH
EE
0-21 (f}
Advertisement
