Advertisement
AM ANTENNA
other devices generating radio frequencies.
Setting Up the AM Antenna
AM
Loop Antenna Set-up
Hole
AM
Loop Antenna
Stopper
Connection
The accessory AM loop antenna must be
connected to ensure proper reception.
External AM antenna
Indoor AM
antenna
Provide a vinyl-coated wire (5 to 6 meters long). Secure one
end to the AM terminal and the other end to a wall or other
high location.
Outdoor AM antenna
!f reception is still poor even when a lead antenna has been
stretched out indoors, stretch out a vinyl-coated wire and se-
cure it outdoors.
Connecting the external AM antenna
Outdoor AM antenna
1
i
t
Indoor AM
antenna!
H
'
4
'
AM loop antenna
NOTE:
Do not detach the AM loop antenna when using the external AM
antenna.
FM ANTENNA
Stretch out both ends.
Correct
Wrong
Wrong
The accessory FM T-type antenna must
be connected to ensure proper recep-
[|_lojo}
When the connecting cable
When the connecting
cable is a 3002
feeder wire
The AM/FM
channel step switch is located on the rear panel
of the digital synthesizer tuner. Before the tuner leaves the
factory, this switch is set to the channel allotment plan of the
area in which the tuner is sold. When the TUNING switch is
given a single push, the frequency display will change in the
following units.
Model
destination
CHANNEL
STEP
switch position
Frequency change
FM
AM
mode
mode
100 kHz | 10 kHz
North
America
and
Continental
South
America
Other countries
NOTE:
© /f the switch is set to the wrong position, correct tuning
will not be possible.
100 kHz/10 kHz
50 kHz/9 kHz
50 kHz
Consu!t your dealer if you are not sure about the channel
allotment plan in your area.
=
|
a
<ARBI133>
|
;
Advertisement
