Channel Control "Punch Through - Universal Remote URC-R6 Owner's Manual

Channel Control "Punch Through"

This "Punch Through" enables you to program
the AVEX R6 so that either the Cable or TV
Channel Controls (CHANNEL UP, DOWN,
LAST, CHANNEL NUMBERS 0-9, +10 and
ENTER) will also operate in other component
modes on the remote control.
STEP 1: Press and hold the component button
you want to add channel control to, such as
DVD or VCR, and the SELECT [SEL] button at
the same time for two seconds until the
Component LED light turns on.
IMPORTANT: You have 30 seconds to
perform the next step while you are in
programming mode. If you do not press a
button within 30 seconds, the component LED
light will turn off. The remote will exit the
programming mode and you will have to start
over.
STEP 2: Press the CHANNEL UP button. The
component LED light will blink once.
COMPONENT
BUTTONS
SELECT
CHANNEL
UP
STEP 3: Press either the TV or CBL button that you
want to use as the source of channel control. The
component LED will blink three times to confirm it is
saved.
Page 21