Programming Multi-Commands To Macro Buttons - Universal Remote URC-R6 Owner's Manual

Notes regarding programming multi-
commands to Macro buttons:
• You can program up to 20 commands on each
Macro button.
• You can program delays in between commands
by pressing the PAUSE button. Each press adds
a one-half second delay.
• Also, if you add the delay time as the first step
of Macro commands, the remote will not send
the Macro unless the button is held for two
seconds. (This is the Press & Hold Function).
• You can also program macro commands in
'layers' by pressing the STOP button in between
commands. (For example, if you press CBL,
009, STOP, 035, STOP, 365, STOP and the
CH+ button in Step 2) the remote will send out
009 at the first press of the 'A' button, and then
send out 035 at the second press, etc.
• You cannot program the CH+ or PAUSE buttons
as macro commands.
PLEASE DO NOT RETURN
THIS PRODUCT TO THE STORE
PLEASE CONTACT OUR TECHNICAL
IF YOU NEED ASSISTANCE, E-MAIL
techsupport@UniversalRemote.com
or dial
SUPPORT CENTER
1-800-901-0800
(9:00AM-6:00PM EST)
Page 16