Connections And Controls - Pronomic HP-2000 Operating Instructions Manual

Pronomic HP-2000 Power Amplifier

Connections and Controls

1. Level control
These controls adjust the level of each channel (displayed in dB). Turn these knobs counterclockwise
when the Limit LEDs are constantly lit, as this indicates that the input signal is too strong.
2. LED signal display
The POWER LEDs light when the amplifier is ON. The
SIGNAL LEDs light to confirm the presence of an input signal greater than 100 mV on that channel of
the amplifier.
Displayed are -20dB, -15dB, -10dB and -5dB.
3. Power switch
Use this switch to turn the unit on or off. Turn the level controls to 0 before turning the power on. A
momentary mute is normal when the amplifier is turned on or off.
Attention: Always switch on the power amplifier after all other connected devices. Always switch off
the power amplifier before all other connected devices.
4. Frequency controller
These controls allow you to set the cutoff frequency for each channel (A and B).
4