Stereo Mode; Bridged Mono Mode - Pronomic HP-2000 Operating Instructions Manual

Pronomic HP-2000 Power Amplifier

Stereo Mode

To operate the unit in stereo mode, first turn off the power amplifier, then slide the mode selector
switch to the upper "stereo" position and connect the wiring properly as shown in the following
diagram.

Bridged Mono Mode

First, turn off the power and slide the mode selector switch to the lower "Bridged" position and connect
the wiring properly as shown in the following diagram. The signal is input to CH-1, so turn the Channel
2 level control all the way down (counterclockwise).
Caution: This mode produces high power. Make sure your wiring and speaker are rated for it.
9