Table of Contents
Advertisement
Pronomic HP-2000 Power Amplifier
Rack Mounting
This power amplifier is suitable for mounting in 19" standard racks as well as for "stack" mounting
without rack.
Use 4 screws and washers for mounting on the front rack rails. We recommend to secure the unit
additionally at the rear or bottom side, as the power amplifier is exposed to strong vibrations especially
during mobile use.
If you are mounting the unit in a rack, please make sure that you open the rear door fully to ensure
proper ventilation.
Connection Examples
The following examples describe the most common ways to use your power amplifier in a sound
system.
Turn off the power amplifier before making any connections.
The unit can be operated in one of two modes (stereo and bridged mono). Refer to the following
speaker terminal wiring diagrams depending on which mode you want to use.
Attention: Musikhaus Kirstein GmbH accepts no liability for damaged loudspeakers caused by
improper wiring, careless use, failure to observe the permissible power rating, or similar.
8
Advertisement
Table of Contents
