Subscribe to Our Youtube Channel
Related Manuals for Pronomic HP-2000
Summary of Contents for Pronomic HP-2000
- Page 1 Pronomic HP-2000 Power Amplifier ArtNo: 00083670 Operating instructions Version 11/2022...
-
Page 2: Table Of Contents
Pronomic HP-2000 Power Amplifier © 2022 Thank you for purchasing this product. To ensure that you are completely satisfied with this product, please read this manual carefully. This manual is protected by copyright. Copying or reprinting, even in excerpts, is only permitted with the consent of Musikhaus Kirstein GmbH. - Page 3 Pronomic HP-2000 Power Amplifier The signal word WARNING indicates hazards that can lead to serious injuries if no precautionary measures are taken. The signal word NOTE indicates general precautions that should be observed when handling the product. Images and screen representations in this manual may differ slightly from the appearance of the actual product, as long as this does not negatively affect the technical characteristics and safety of the product.
- Page 4 Pronomic HP-2000 Power Amplifier Before cleaning the product, please turn it off and disconnect it from the power supply. Clean the product only with a soft, dry cloth. Do not use paint thinner, solvents, cleaning fluids or chemically impregnated wipes.
-
Page 5: Connections And Controls
Pronomic HP-2000 Power Amplifier Connections and Controls 1. Level control These controls adjust the level of each channel (displayed in dB). Turn these knobs counterclockwise when the Limit LEDs are constantly lit, as this indicates that the input signal is too strong. - Page 6 Pronomic HP-2000 Power Amplifier 5. Filter switch This switch allows you to select the filter type for each channel (A and B). Off = No filters High Cut = low pass filter. The amplifier outputs the frequencies that are lower than the cut-off frequency set with the frequency controller.
-
Page 7: Processing Switch Diagram (Item
Pronomic HP-2000 Power Amplifier Processing Switch Diagram (Item 6, Page 5) -
Page 8: Technical Specifications
Pronomic HP-2000 Power Amplifier Technical Specifications Output power (8 Ohm) 2x 2000W Output power (4 Ohm) 2x 3000W Output power (2 Ohm) 2x 4500W Output power (8 Ohm/bridged) 6000W Output power (4 Ohm/bridged) 9000W Frequency response (1W at 8 20 Hz - 20 kHz ±0.5dB... -
Page 9: Rack Mounting
Pronomic HP-2000 Power Amplifier Rack Mounting This power amplifier is suitable for mounting in 19" standard racks as well as for "stack" mounting without rack. Use 4 screws and washers for mounting on the front rack rails. We recommend to secure the unit additionally at the rear or bottom side, as the power amplifier is exposed to strong vibrations especially during mobile use. -
Page 10: Stereo Mode
Pronomic HP-2000 Power Amplifier Stereo Mode To operate the unit in stereo mode, first turn off the power amplifier, then slide the mode selector switch to the upper "stereo" position and connect the wiring properly as shown in the following diagram. -
Page 11: Circuit Diagram
Pronomic HP-2000 Power Amplifier Circuit Diagram... -
Page 12: Weee Declaration
Pronomic HP-2000 Power Amplifier WEEE Declaration (Waste of Electrical and Electronic Equipment) Your product has been designed and manufactured using high quality materials and components that are recyclable and reusable. The symbol means that your product must be disposed of separately from household waste at the end of its life.
Need help?
Do you have a question about the HP-2000 and is the answer not in the manual?
Questions and answers