Related Manuals for nvent T50 Series
Summary of Contents for nvent T50 Series
- Page 1 T-SERIES Air Conditioner t50 Model INSTRUCTION MANUAL Rev. I © 2020 nVent 89056286 P/N 10-1008-203...
-
Page 2: Table Of Contents
F-GAS INFORMATION ..................................13 NOTE: Some of the information in this manual may not apply if a special unit was ordered. If additional drawings for a special unit are necessary, they have been inserted. Contact nVent Equipment Protection if further information is required. -
Page 3: Receiving The Air Conditioner
Damage evident upon receipt should be noted on the freight bill. Damage should be brought to the attention of the delivering carrier -- NOT to nVent Equipment Protection -- within 15 days of delivery. Save the carton and packing material and request an inspection. Then file a claim with the delivering carrier. -
Page 4: Installation Instructions
Amb Temp °F/°C Weight lb./kg T501226GXXX 220/230 50/60 9.0/10.9 11040/12400 131/55 164/74.6 XXX will be replaced with a three-digit number designating all desired options. Consult the factory for specific model numbers. DIMENSIONAL DRAWING © 2020 nVent 89056286 - 4 -... -
Page 5: Mounting Cutout Dimensions
MOUNTING CUTOUT DIMENSIONS Externally Mounted Internally Mounted Cutout Instructions (As viewed from outside of enclosure) NOTE: Dashed lines represent air conditioner. © 2020 nVent 89056286 - 5 -... -
Page 6: Components List
Filter, Air, Reusable 89057618 Filter/Dryer 52-6028-06 Freeze Stat 10-1061-05 Head Pressure Control Switch 52-6104-26 Impeller, Evaporator 10-1091-139 Service Cord 52-6035-141 Terminal Block 10-1003-31 Thermal Expansion Valve 89162241 Thermostat, SPDT, 60-101F 10-1061-03 Thermostat, SPST, 55-100F 10-1061-02 © 2020 nVent 89056286 - 6 -... -
Page 7: Components
COMPONENTS © 2020 nVent 89056286 - 7 -... -
Page 8: Wiring Diagram And Schematic
WIRING DIAGRAM AND SCHEMATIC WIRE DIAGRAM (ACTUAL UNIT OPTIONS MAY VARY) © 2020 nVent 89056286 - 8 -... -
Page 9: Schematic (See Label On Unit For Actual Options)
SCHEMATIC (SEE LABEL ON UNIT FOR ACTUAL OPTIONS) © 2020 nVent 89056286 - 9 -... -
Page 10: Temperature Control
Continued operation under the above conditions can and will damage and shorten compressor life. The air conditioner features an easily removable inlet filter to facilitate necessary cleaning. There should be no reason to neglect this necessary maintenance. © 2020 nVent 89056286 - 10 -... -
Page 11: How To Remove, Clean Or Install A New Inlet Air Filter
CAUTION Operation of the air conditioner in areas containing airborne caustics or chemicals can rapidly deteriorate filters, condenser coils, blowers and motors, etc. Contact nVent Equipment Protection for special recommendations. REFRIGERANT LOSS Each air conditioner is thoroughly tested prior to leaving the factory to insure against refrigeration leaks. Shipping damage or microscopic leaks not found with sensitive electronic refrigerant leak detection equipment during manufacture may require repair or recharging of the system. -
Page 12: Trouble Shooting
(replace control box cover for safety). This will pass the switch in the thermostat. Turn the power on and if both blowers and the compressor come on, the thermostat needs to be replaced. © 2020 nVent 89056286 - 12 -... -
Page 13: Symptoms And Possible Causes
Unit blows breakers Short in system Drain plugged Getting water in enclosure Drain tube kinked Enclosure not sealed (allowing humidity in) For additional technical support (i.e., amp draw, pressures, temperatures), contact nVent Equipment Protection at 800-896-2665. F-GAS INFORMATION T501226GXXX T501246GXXX Refrigerant Kühlmittel... - Page 14 NOTES © 2020 nVent 89056286 - 14 -...
- Page 15 NOTES © 2020 nVent 89056286 - 15 -...
- Page 16 Rev. I © 2020 nVent 89056286 P/N 10-1008-203...
Need help?
Do you have a question about the T50 Series and is the answer not in the manual?
Questions and answers