Led Control - Helios SA-5 10 Installation And Operating Specification

Installation and Operating Specification SA-5 10

5.4 LED control

With internal jumper "J2 LED" it can be selected whether the LED
registers the operation of the 5-step switch or if it is controlled via
an external contact.
Jumper "J2 LED"
LED
J2
LED
J2
int
ext
L-BAL-E328-GB 2023/33 Index 002
LED operating indication 5-step switch
Jumper "J2" in position up (factory setting) = "int"
Switch position 0: LED = OFF
•
int
Switch position 1 - 5: LED = ON
•
ext
External LED control
Jumper "J2" in position down = "ext"
Contact at terminals "LED" - "GND" open: LED = OFF
•
Contact at terminals "LED" - "GND" closed: LED = ON
•
LED GND
With a potential-free contact at terminals "LED" + "GND",
the LED can be switched on and off.
In the case of a connected device with status report via a
digitally coded signal, the status can be displayed via the
LED flashing code.
Part.-No.
11/14
Electrical installation