Installation and Operating Specification SA-5 10
The device is designed for vertical installation (bottom cable
•
inlet). A horizontal or reclined installation is only permissible
after technical release of the manufacturer!
Remove the connection cover for mounting and connection, and
•
subsequently close it again carefully.
Use the templates printed on the device packing to mark the
•
fastening bore holes.
Assemble the device on a clean and stable base. Do not distort
•
during assembly! Use the appropriate mounting devices for
proper installation of the unit!
Drilling template on packing
Bohrschablone
drilling template
Schraube
max
4,5 mm
screw max
4,5 mm
91 mm
Gehäuse / housing
106 mm
L-BAL-E328-GB 2023/33 Index 002
Vertical mounting
1 Lid screw (tightening torque 1.1 Nm)
Part.-No.
7/14
Mounting