Advertisement
UNPACKING
Refer to Figure 1
• Examine shipping carton for freight damage before opening.
If shipping carton is damaged file a claim with the carrier
immediately.
• Carefully remove all contents from shipping carton. The
shipping carton contains:
Figure 1
NOTE: Contact the customer service center if any of these
parts are missing.
NOTE: After unit is assembled dispose of all packaging material
in an environmentally safe way.
INSTALLATION
Refer to Figures 1 to 6
Tools Needed:
(not included)
- Electric Drill
- 1/4" Drill Bit
- 1/4" Masonry Bit
- Screwdriver
Additional Parts Needed:
4" Flexible dust collection hose, hose clamps and any
additional adapters, specific to your application.
ASSEMBLY
• Plan the shop floor layout before installing the
Dust Collection Network.
• The clear plastic components assemble with a snug friction
fit and do not require glue or special tools for assembly.
• The clear sections allow the user to see and remove
blockages quickly and easily at any point in the system.
WARNING
Risk of serious bodily injury. ALWAYS turn off machine before
removing obstructions.
• The outside pipe joints may be wrapped in duct tape to
improve the vacuum seal.
• Make the best use of the 3' length pipes. The pipes can
be cut to size using a pipe cutter or hack saw with blades
recommended for cutting plastic. Make sure all cuts are 90°
and smooth.
- Pipe Cutter or Hacksaw
with blades recommended
for cutting plastic.
(not included)
Figure 2
• Assemble a "Y" connector and a blast gate.
• Always assemble the blast gates at the end of the "Y"
connector directed toward the tool.
• When mounting the "Y" connectors to the wall always angle
the "Y" connector away from the wall to allow clearance for
the Blast Gate.
• IMPORTANT: The OUT on the blast gate MUST be oriented
toward the "Y" connector.
• Figure 3 shows the
CORRECT
with the air flowing toward the vacuum/dust extractor.
Figure 3
• Figure 4 shows an
INCORRECT
Figure 4
assembly for the "Y" connectors
assembly of the "Y" connectors.
Advertisement
