Panasonic KX-MB283BR Service Manual page 65

8.1.3. DOCUMENTS THE UNIT CAN SEND
8.1.3.1. Using the auto document feeder
8.1.3.2. Using the scanner glass
Effective scanning area
Note for the auto document feeder and the scanner glass
• Check that ink, paste or correction fluid has dried completely.
• To set a document with a width of less than 210 mm when using the auto document feeder, we recommend using the scanner
glass to copy the original document onto A4 or letter-sized paper, then setting the copied document.
• Do not set documents that do not satisfy the requirements of size and weight when using the auto document feeder. Make a copy
of the document using the scanner glass and set the copy.
• Remove clips, staples or other fasteners when using the auto document feeder.
• When using the auto document feeder, the total height of the documents when laid flat, must be less than 4mm. If the documents
exceed the capacity of the auto document feeder, they may fall or cause a jam in the feeder.
• Do not set the following types of documents when using the auto document feeder: (Make a copy of the document using the
scanner glass and set the copy instead.)
- Chemically treated paper such as carbon or carbonless duplicating paper
- Electrostatically charged paper
- Badly curled, creased or torn paper
- Paper with a coated surface
- Paper with printing on the opposite side that can be seen through the other side, such as newsprint
65
KX-MB283BR