Warranty Claims - Exclusion Of Liability; Regulations - Guidelines; Shipping; Receipt - Helios WHSH HE 24 V (0-10 V) M Installation And Operating Instructions Manual

Installation and Operating Instructions
EN
m
DANGER
n mo
CHAPTER 2

TECHNICAL DATA

ATTENTION
Hydraulic Unit WHSH HE 24 V (0-10 V) M
full compliance with the installation and operating instructions.
1 .4 Warranty claims – Exclusion of liability
All versions of this documentation must be observed, otherwise the warranty shall cease to apply. The same applies
to liability claims against Helios. The use of accessory parts, which are not recommended or offered by Helios, is not
permitted. Any possible damages are not covered by the warranty. Changes and modifications to the unit are not per-
mitted and lead to a loss of conformity, and any warranty and liability shall be excluded in this case. Claims of any kind
against the manufacturer and/or its representatives due to damage caused by improper use cannot be acknowledged.
1 .5

Regulations - Guidelines

If the product is installed correctly and used to its intended purpose, it conforms to all applicable regulations and EC
directives at its date of manufacture.
1 .6

Shipping

m Personal injury and/or material damage due to incorrect shipping!
− Use suitable means of transportation and lifting.
− Fittings such as handwheels or handles must not be used for absorbing external forces, e.g. misused as attach-
ment points for lifting devices etc.
− Wear suitable protective clothing.
− Only touch with suitable protective gloves. Threads, bores and corners have sharp edges.
The unit is packed ex works in such a way that it is protected against normal transport strain. Carry out the shipping
carefully. It is recommended to leave the hydraulic unit in the original packaging until assembly.
1 .7

Receipt

The shipment must be checked for damage and correctness immediately upon delivery. If there is any damage,
promptly report the damage with the assistance of the transport company. If complaints are not made within the agreed
period, any claims could be lost.
1 .8

Storage

When storing for a prolonged time, the following steps are to be taken to avoid damaging influences: Control system
protection by dry, airtight and dust-proof packaging (plastic bag with desiccant and humidity indicators). The storage
site must be vibration-free, water-tight and free of temperature variations. When transhipping (especially over longer
distances) check if the packing is adequate for method and manner of transportation. Damages due to improper
transportation, storage or commissioning are not liable for warranty. Packaging material must be disposed of in an
environmentally friendly manner.
1 .9

Scope of delivery

The hydraulic assembly is supplied pre-assembled.
1 x WHSH HE 24 V (0-10V) M
The assembly consists of:
– circulating pump,
– 3-way valve with actuator
– piping,
– check valve
– shut-off valve with thermometer (flow/return)
– fixing screws
– 1 x installation and operating instructions
2 .0 Technical data
The safety instructions specified in section 1.2 must be observed!
m Risk of material damage!
Appropriate measures (e.g. safety valves) must be taken to ensure that the max. operating pressures and the max.
and min. operating temperature limits are not breached.
Performance data
Nominal size:
Max. operating pressure:
Max. operating temperature:
k value:
vs
Opening pressure check valve:
Centre distance:
Connections:
Weight:
Ref . no . 06310
DN 32
10 bar PN10
95 °C
8.1
20 mbar
125 mm
G 2 AG, flat-sealing
9,6 kg
2