Sym MMBCU Owner's Manual page 11

Ⓚ Fuel Gauge
This digital fuel gauge shows the fuel level when the main switch is turned on. There are 5
sectors in the fuel gauge. F means full and E means empty. The low fuel indicator will be on
when the fuel level is at E. please refuel the fuel tank immediately.
CAUTION！！
 Turn main switch to
engine start.
 Turn the Idling Start & Stop switch to "
only when the scooter is ridden and reaches the setting condition (engine heated).
 For safety start, it is recommended pull the brake lever while pulling throttle for starting.
 When engine temperature is low or the previous engine stop is not controlled by EFi system,
the Idling Start & Stop mode will not be activated.
 When Idling Start & Stop switch is turned on, the engine will stop while idling, so the EFi
system is not able to timely adjust the idle learning and O2 sensor learning. It is suggested to
turn off the Idling Start & Stop switch and carry out the idle speed learning every 5,000km.
 When the idle learning step is not proper, the engine start can possibly be difficult. When the
starting RPM is low, the EFi system will automatically cancel the Idling Start & Stop
mechanism, hence there will be no Idling Start & Stop function for EFi compulsory idling
learning.
 Idling start & stop mechanism can be recovered when main switch is turned off and turned on.
 Vehicle speed is very important for Idling Start & Stop mechanism. For driving safety, if the
speed is abnormal, please Contact your SYM authorized dealer for repair.
Display Shift
When the main switch is turned on, under "TOTAL" mode, the below display mode can be shifted
circularly by pushing the M button once.

shows the total distance in kilometers the scooter has been ridden and
cannot be reset.
 Under
 Under "UNIT" mode, push S button for more than 2 seconds , metric/imperial can be
interchangeable.(Including speed/TOTAL/TRIP/OIL)
Time Setting
 This clock displays 24-hour mode.
 When the main switch is turned on, this clock will display 24-hour mode.
•
Under mode, push the "M" button for more than 2 seconds to enter time setting mode.
Quickly push "M" button (0.5 second) to select setting mode (hour→tens digit in minute→
units digit in minute→exit), quickly push "S" button (0.5 second) once the digit will increase 1
each time. If the clock is idled about 30 seconds while setting, it will exit setting mode
automatically and starts working again.
/
Low fuel Indicator Light
" "
position, press the start button and pull the brake lever for the first
mode, push S button for more than 2 seconds to reset.
" position, the Idling Start & Stop mode is activated
9
UNIT