Advertisement
6. Alignment Procedures
Remove
the turntable
covering,
then
adjust
it by a VR
shown.
Turning
clockwise
permits
increased
RPM, while
turning counterclockwise permits decreased RPM.
45rpm : VR401
33rpm : VR402
Adjust
it with
a VR
shown.
Turning
clockwise
causes
the position to shift outwards, while turning counterciock-
wise causes it to shift inwards.
6-(3) Tonearm foilowing sensitivity
adjustment (Fig. 13)
With the tonearm at the UP position, adjust it with VR201
shown. The output voltage should be 3.5 + 0.2 V between
(1) and (2) of test point (P203).
(Adjust the output to this
voltage at a lapse of more than 3 minutes after power ON.)
When setting the tonearm
ass'y to the right end,
string the carrier rope so that the spring is located
above screw (A) shown in Fig. 14.
Length of rope: 529 mm (between knots)
[—7—Motor RPM speed adj
Mechénitm cever section:
6
VR201 adj. hole
Fig. 13
L-E600
Shutter
Guide pin
Arm UP sensor
——_—!
Fig. 14
Advertisement
