Advertisement
Fig. 1
. SPEED SELECT button
Select the turntable speed as required.
. Lock buttons
Press these buttons to open the cover.
Note:
If the cover
is opened
during playback of a record,
playback will stop and the tonearm will automatically
return to the rest position.
. READY switch
ON (-—):
Press to IN position to turn on the power.
The AUTO indicator will light.
OFF (mM): Press again to set to OUT position to
switch the power off.
Note:
@ When the cover is opened, playback will not start
even if the READY button is set to ON.
@
Even when the READY
switch is off, this turntable
consumes a small amount
of electricity. This is to
return the tonearm to the rest position when the
READY
switch is set to OFF or the cover is opened
during playback. If you are not going to use the
turntable for a long time, disconnect the power cord
from the wall socket.
4,
10.
11,
UP/DOWN button
If this button is pressed during playback, the tonearm
is raised and the MANUAL
indicator will light to show
that manual playback is being employed.
When manual playback is used, press this button to
lower the tonearm
after moving the tonearm using the
"<@" (START) and " ® " (STOP) buttons.
At the same
time that the tonearm
is lowered, the
AUTO
indicator
lights to show that automatic play-
back is being employed. If this button is pressed when
the tonearm is raised, the tonearm will be lowered; if it
is pressed when the tonearm
is lowered, the tonearm
will be raised. It can be used to raise the tonearm to
pause during the manual
or automatic playback of a
record,
. START button (<4)
Press
this
button
to
start
automatic
playback.
For
manual
playback,
hold
this
button
pressed. When
holding this button
pressed, the tonearm
will start to
move
and the indicator will change
from
AUTO
to
MANUAL;
release this button at the desired position
The tonearm will stop at that position; now press the
UP/DOWN button to start playback:
If this button is pressed during playback, the tonearm
will move to the left automatically (~—) and return to
the rest position; if the UP/DOWN
button is pressed
while the tonearm is moving, playback will start at that
position.
This allows it to be used for the playback of
any tune (music scanning)
- STOP button ( >)
If this button
is pressed during playback, the tonearm
will move to the right (—=) automatically and when it
reaches the rest position, the tonearm indicator will go
out and the turntable will stop.
If the UP/DOWN
button is pressed while the tonearm
is moving, playback will start again at that position, so
this can be used for music scanning. When the tonearm
stops in the up position (manual playback) the tone-
arm will move
to the right (=) while this button is
pressed.
. SIZE SELECT button
Used for automatic
selection of the position where the
tonearm
will
descend
and where
playback
will end
according to the record
MANUAL, AUTO indicator
Indicates manual playback when the MANUAL indi-
cator lights, and automatic playback when the AUTO
indicator lights.
. EP adaptor
Place the adaptor on the center spindle when playing
an EP with a large center hole.
Tonearm indicator
This
indicator
lights
when
the
START
button
is
pressed and during the playback showing the position
of the stylus.
Clamp
Move
this clamp to the right (¥) to release the tone-
arm lock, If the tonearm is locked, playback is impossi-
ble. If the clamp is moved to the left (¥~), the tone-
arm will be locked in the up position. Used in this
position when transporting the turntable
L-E600
No. 2586
Advertisement
