Advertisement
When the tonearm
is lifted up, the turntable enters
manual
mode.
When
it is lowered
down,
the
manual mode is canceled.
2-5 Precautions on operation
1) Do not start the turntable without a record
mounted.
2) Correctly set the SIZE select switch.
2-6 Operation check (Summary)
servicing.
1) When only turning ON the POWER
switch with
the
cover
closed,
the turntable
and
tonearm
should both not move.
3) With the SIZE select switch (S102) set to "30",
when pressing the START switch (S103) from
the situation of item 1), the tonearm should
move inwards, the LED (D601) at the cartridge's
tip light and the turntable rotate. In addition,
the tonearm should pause for about 2 sec before
being led in.
4) While pressing the START switch with the SIZE
select switch set to "17" from the situation of
item 3), when the tonearm passes through the
"17"
lead-in position, the green
LED
(D108)
should go out and the red LED (D109) light.
NOTE:
Special
cases
of canceling
the
manual
mode.
Turning the power OFF once:
When canceling the manual mode without the
tonearm lowered down.
Opening the cover once:
Not recommended
1)
2)
3) Release the arm lock lever.
side, referring to Fig. 2.)
(Pull it to your
When
stopping pressing the START switch, the
tonearm should stop action.
5) When pressing the UP/DOWN
switch from the
situation of item 4), the tonearm should lower
down, the red LED go out and green LED light.
6) Upon play under the situation of item 5), the
tonearm should follow the groove normally.
7)When
opening the cover or turning OFF
the
POWER
switch from the situation of item 6),
the tonearm
should return to its rest and the
turntable stop rotation.
NOTE:
On method of test with cover opened
As the cover switch (S101) is connected
to the cover lock mechanism at the right
in front of the motor board, push in the
lock section (oval black mold piece) about
4~5 mm
(not more than 5 mm). In this
way, it is possible to perform the trial test
of items 1) to 7).
Advertisement
