Advertisement
13. Power Cord Connections in Different Areas
03830-001
£302177-001
£302177-001
Connector
FUSE C. Board
FUSE C. Board
Z
eeeee)
Power Cord
amt
Power Cord
nad
To Transformer
To Transformer
'
To Voltage Selector
Fower Cord
UK.
USA.
Europe.
US. Military Market
Canada
Australia
and Other Countries
Hise
9.
13-(1) How to handle the solderless connector
In this turntable, a solderless connector is used to connect
58
Se
the power cord with
the primary lead wire of the power
Nhe
About 15mm
transformer.
'
me
When it is unavoidable to replace this connector for replace-
ment
of the power
transformer,
or the like, positively
perform
the replacement in accordance with the following -
procedure to avoid dangers.
Cut at near the edge
@ Connector part number
Fig. 31
Fig. 32
E03830-001
2. Peel off the coverings so that the respective conductor
tops appear by about 15 mm as shown in the Fig. 32.
Do not use those (small cutting pliers, etc.) other than
Note: In the case of stranded wires, test each wire,
veqular-tools,
3. Adjust the tips of the power cord and the primary lead
®@ Tools
Tool for installing solderless connectors,
Metal sleeve
Solderless connector
Fig.
i
© Replacement
9,38
Fig. 34
1, Cut both the power cord and the primary lead wire at
4
near the edge of the connector to be replaced.
Note:
Do not re-use the used connector.
Note:
Perform a complete securing.
in the Fig. 35,
tube for safety. Furthermore, clamp it for out of
touch with metal part.
The clamped markes
These shall not be _ shall locate at the nearly
easy todraw out.
equal central part of
the metal sleeve.
More than
4mm
Fig. 35
—_
L-£600
No. 2586
a
Advertisement
