Table of Contents
Advertisement
[ 2 9 ] G E T T I N G S T A R T E D
Setting the Dial Mode
Sets the dial mode to tone or pulse. Most phone systems use tone dialing; the
default setting is tone dialing. Set the dialing mode to match the dialing system
used by your local phone service.
• If you are not sure of your dialing system, set the unit to tone dialing. Make a trial call. If
the call connects, leave the setting as is; otherwise set the unit to pulse dialing.
• If your phone system requires pulse dialing and you need to send DTMF tones in certain
situations during a call, you can switch over to tone dialing (refer to "Tone Dialing Switch-
over" on page 36).
1) Press the MENU soft key. Select the Global Setup
menu, and then the Dial Mode submenu.
∧
2) Press cid/vol/
or redial/p/vol/
(the initial setting is Tone).
P u ls e
3) Press the OK soft key. You will hear a confirmation
tone.
Setting Voice Mail Tone
Voice Mail Tone sets the voice mail tone. If your service does not support SDT
message signal, set your VMWI (Visual Message Waiting Inculcator) not to detect
SDT message signal.
1) Press the MENU soft key. Select the Global Setup menu, and then the Voice Mail
Tone Submenu.
∧
2) Press cid/vol/
or redial/p/vol/
message indication (SDT message signal) to On or Off.
3) Press the OK soft key. You will hear a confirmation
tone.
∨
to select
or
Tone
∨
to set the voice
w w w . u n i d e n . c o m
Advertisement
Table of Contents
