Installing The Beltclip; Headset Installation - Uniden TRU 448 Series Owner's Manual

Installing the Beltclip

Headset Installation

[ 58 ] A D D I T I O N A L I N F O R M A T I O N
Register the Security Code
1) Unplug the AC adapter.
2) Press and hold find hs/transfer on the base while you plug in the AC Adapter
until the status LED on the base flashes.
3) Press talk/flash. "
When the operation is finished "
status LED is turned Off. You will hear a confirmation tone and the phone returns
to the standby mode.
• You must complete the registration operation within 30 seconds, or the phone returns to
standby mode.
• During the registration operation, you cannot receive an incoming call, page, or make a call.
To a t t a c h t h e b e l t c l i p
Insert the beltclip into the holes on each side of the handset.
Press down until it clicks.
To re m ove t h e b e l t c l i p
Pull both sides of the beltclip to release the tabs from the holes.
Your phone may be used with an optional headset, the Uniden HS910. To
use this feature, insert the headset plug into the headset jack. Your phone
is ready for hands-free conversations. (Headset may be purchased by calling
the Uniden Parts Department or visiting the web site. See page 9.)
" appears.
" appears and the