Chain Dialing; Erasing A Stored Number From Memory; Redial - Uniden EXS9500 Owner's Manual

Uniden exs9500: user guide

Table of Contents

NOTE

An error sounds and the

erase procedure will be

canceled if more than 20

seconds elapse between

each keystroke.

CHAIN DIALING

On certain occasions after dialing a number,

you may be requested to enter an access

code, such as your account number. You can

enter this number into a memory location

for later use by doing the following.

1) Store the access code into one of the

memory locations (01-20) or memory keys

, or

following steps 1-5 above.

2) Dial the party or service main number.

3) When you need to enter the special number, press

the memory location (01-20) or memory keys

1) Remove the handset from the base unit.

2) Press the

button twice.

mem

3) Press the memory location (01-20) or memory key

A tone indicates that the stored number is erased from memory.

The

key redials the last number dialed. The redialed number

redial

can be up to 32 digits long.

followed by

mem

, or

to be erased.

Table of Contents