Troubleshooting - unicraft PG Series Operating Instructions Manual

TROUBLE SHOOTING:
NO VOLTAGE IN A.C. SOCKET (13.1):
IS THE PROTECTION SWITCH ON?
IS THE REQUIRED VOLTAGE SELECTED ON THE SWITCH? ⊗
ARE THE PANEL CABLES IN GOOD STATE?
IS THE CONDENSER IN GOOD CONDITIONS? ⊗⊗
IS THERE ALWAYS LACK OF VOLTAGE WHEN THE CONDENSER
HAS BEEN ENERGIZED AT THE CONNECTORS WITH A 12V BATTERY? ⊗⊗
TAKE THE GENERATOR TO THE NEAREST SERVICE CENTRE.
NO VOLTAGE IN CHARGER SOCKET (14.1):
IS THE PROTECTION FUSE IN GOOD CONDITION?
IS THE DIODE IN GOOD CONDITION?
ARE THE PANEL CABLES IN GOOD STATE?
TAKE THE GENERATOR TO THE NEAREST SERVICE CENTRE
THE ENGINE DOES NOT START (15.1):
IS THERE ANY FUEL IN THE TANK?
IS THERE AIR IN THE FEEDING CIRCUIT? ⊗⊗
IS THE SPARK PLUG CONNECTED? ⊗⊗⊗
TAKE THE GENERATOR TO THE NEAREST SERVICE CENTRE
YES
YES
YES
YES
YES
YES
YES
YES
YES
IS THE FUEL TANK TAP OPEN? ⊗
YES
YES
IS THE CHOKE ON? ⊗⊗⊗
YES
IS THERE OIL IN THE ENGINE?
YES
YES
NO
NO
NO
NO
NO
NO
NO
NO
NO
NO
NO
NO
NO
NO
12
ACTIVATE
ACTIVER
REPAIR
REPLACE
GENERATOR OK
⊗ ONLY WHEN FORESEEN
⊗⊗ SINGLE-PHASE GENERATORS
SUBSTITUTE
SUBSTITUTE
REPAIR
FILL TANK
OPEN
ELIMINATE
ACTION
FILL UP
CONNECT
⊗ ONLY WHEN FORESEEN
⊗⊗ ONLY FOR DIESEL ENGINE
⊗⊗⊗ ONLY FOR EXPLOSION ENGINE