Fuse And Relay Locations - New Holland Boomer 45 Operator's Manual

Table of Contents

Advertisement

Fuse and relay locations

Fuse and relay locations
Main fuse panel
The chassis fuse block (1) is located on the left-hand side
of the steering column, underneath shrouding.
NOTICE: Always replace blown fuses with the size spec-
ified for that circuit.
NOTICE: Always disconnect ground cable at battery be-
fore replacing a fuse.
From top to bottom, the fuse block contains the following
fuses:
Fuse configuration with air ride suspension seat
Fuse # Fuse
10 A
Size
SPARE
1
20 A
2
10 A
3
5 A
15 A
SPARE
4
10 A
5
15 A
15 A
20 A
6
SPARE
7
10 A
8
5 A
9
10 A
10
10 A
11
20 A
7 - MAINTENANCE
Circuit
Head lamp
Combination switch, head lamp relay, brake lamp relay, brake switch
Horn relay
Alternator, hazard switch, horn switch, Forward Neutral Reverse (FNR)
switch, diesel particulate filter (DPF) switch, Engine Speed Management
(ESM) switch
Engine control
Engine control unit(ECU)
unit(ECU)
Turn signals
Hazard switch, Combination Switch
Solenoid valve Rear Power Take Off (PTO) switch, rear PTO solenoid
Work lamps
Front corner lamp switch
Controller
Cluster, Vehicle Control Unit (VCU), brake latch switch, seat switch
Engine Control Fuel heater relay, glow plug relay, starter motor relay,
Engine sensor Cam position sensor, inlet metering valve, air mass flow sensor
ECU POWER
Hazard switch, cluster, diagnostic connector, main relay, engine, parking
/ HAZARD
brake switch
20A AIR
AIR SUSPENSION
SUSPENSION
Circuits protected
7-68
1
NHIL22CT00352AA
2
NHIL22CT00369AA

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents