Step 4: Install The Switch; Install The Switch In A Rack - NETGEAR MS324TXUP Hardware Installation Manual

24-Port Multigig Ethernet Ultra60 PoE++ Smart Switch with 4 SFP Ports Hardware Installation
4. Verify that the package contains the following items. Refer to the switch package
contents figure above.
Table 6. Identification of package contents
Figure Callout Description
1 MS324TXUP
2 Detachable power cord (varies by region)
3 Eight small screws to attach the brackets to the switch
4 Four large screws to attach the brackets to the rack (two screws for each side).
5 Rubber pads for tabletop installation
6 Installation guide
7 Rack mounting brackets
5. If any item is missing or damaged, contact your local NETGEAR reseller for
replacement.

Step 4: Install the switch

You can install the switch in a standard 19-inch (48.26-centimeter) network equipment
rack or on a flat surface.

Install the switch in a rack

To install the switch in a rack, you need the 19-inch rack-mount kit supplied with the
switch.
To install the switch in a rack:
1. Attach the supplied mounting brackets to the side of the switch.
2. Insert the screws provided in the product package through each bracket and into
the bracket mounting holes in the switch.
3. Tighten the screws with a No. 2 Phillips screwdriver to secure each bracket.
4. Align the mounting holes in the brackets with the holes in the rack, and insert two
pan-head screws through each bracket and into the rack.
Installation
Guide
25 Hardware Installation Guide