GETTING STarTED
Installing Your Phone
1.
Unpack the handset, battery pack,
Charge the Battery
and battery cover. If you need to
remove the battery cover, press in
on the notch and slide the cover
down and off.
2.
Line up the battery connector with the jack inside the handset.
(The battery connector will only fit one way.)
.
Push the connector in until it clicks into place; tug gently on the
wires to make sure the battery pack is securely connected.
4.
Replace the battery cover and slide it into place.
.
Connect the AC adapter to the
plug into the notch.
6.
Plug the other end of the adapter into a standard 120V AC outlet.
7.
Place the handset in the base with the display facing forward. The
display on the handset should light up; if it doesn't, reseat the
handset or try plugging the AC adapter into a different outlet.
Charge the handset completely (about 15 hours) before using it.
Use the telephone cord to connect the
Connect the Telephone Cord
standard telephone wall jack.
1.
Pick up the handset from the cradle and press
Test the Connection
hear a dial tone, and the display should say Talk.
If you don't hear a dial tone or the display says Check Tel Line,
check the connection between the base and the phone jack.
2.
Make a quick test call. (Press
If you keep hearing a dial tone, try changing to pulse dialing mode.
jack on the base. Set the
AC IN 8V
TEL LINE
to hang up.)
End
jack on the base to a
. You should
Talk