Cobalt Digital Inc 9323 Product Manual page 33

Installation and Setup
9323G-OM (V4.6)
CAUTION
If required, make certain Rear I/O Module(s) is installed before installing the
card into the frame slot. Damage to card and/or Rear I/O Module can occur if
module installation is attempted with card already installed in slot.
Note: Check the card packaging for a Rear I/O Module connection label. In some
cases, this label is shipped with the card and to be installed on the Rear I/O
connector bank corresponding to the slot location of the card.
Install the card into a frame slot as follows:
Determine the slot in which the card is to be installed.
1.
Open the frame front access panel.
2.
While holding the card by the card edges, align the card such that the
3.
plastic ejector tab is on the bottom.
Align the card with the top and bottom guides of the slot in which the
4.
card is being installed.
Gradually slide the card into the slot. When resistance is noticed, gently
5.
continue pushing the card until its rear printed circuit edge terminals
engage fully into the rear I/O module mating connector.
CAUTION
If card resists fully engaging in rear I/O module mating connector, check for
alignment and proper insertion in slot tracks. Damage to card and/or rear I/O
module may occur if improper card insertion is attempted.
Verify that the card is fully engaged in rear I/O module mating connector.
6.
Close the frame front access panel.
7.
Connect the input and output cables as follows:
8.
•
If the card is being installed in a PN 8310-BNC or 8310-C-BNC
frame, refer to the label on the connector bank corresponding to the
card's slot location for connector designations.
•
If the card is being installed in a frame using a specific 932X Rear I/O
Module, connect cabling in accordance with the appropriate diagram
shown in Table 2-1, "932X Rear I/O Modules" (p. 2-5).
Repeat steps 1 through 8 for any other cards.
9.
Note: The card BNC inputs are internally 75-ohm terminated. It is not necessary to
terminate unused BNC inputs or outputs.
Note: To remove a card, press down on the ejector tab to unseat the card from the
rear I/O module mating connector. Evenly draw the card from its slot.
If network remote control is to be used for the frame and the frame has
10.
not yet been set up for remote control, perform setup in accordance with
Setting Up Card Network Remote Control (p. 2-20).
Note: If installing a card in a frame already equipped for, and connected to
DashBoard™, no network setup is required for the card. The card will be dis-
covered by DashBoard™ and be ready for use.
9323 GROUP PRODUCT MANUAL
Installing the Card Into a Frame Slot
2-3