Resetting The Scanner - Uniden BC72XLT Owner's Manual

BC72 Paper OM.fm Page 53 Monday, October 25, 2004 3:11 PM
Weather The squelch
scan might need to
doesn't be adjusted.
work.
The antenna
might need to
be adjusted.

Resetting the Scanner

If the scanner's display locks up or stops operating
properly, you might need to reset the scanner.
Caution: This procedure clears all the information
you have stored in the scanner. Before you reset the
scanner, try turning it off and on to see if it begins
working properly. Reset the scanner only when you
are sure it is not working properly.
1. Turn off the scanner.
2. While holding down 2, 9, and Hold, turn on the
scanner. It takes about 3 seconds to initialize
and CLEAr appears.
Adjust the squelch
threshold. See
"Turning On The
Scanner and
Setting Squelch" on
Page 33.
Check the antenna
connection.
Troubleshooting
53