Direct Entry Search Hold Mode - Uniden BC72XLT Owner's Manual

BC72 Paper OM.fm Page 44 Monday, October 25, 2004 3:11 PM
3. Press Func +
searches, starting from the frequency you
entered in Step 2.
If you enter a frequency that is out of range, the
scanner sounds an error tone and Error appears.
Press Func + to change the search direction
downward or Func +
direction upward. Frequencies appear during the
search.
Notes:
• You can set the delay function on or off during
the search or while the search stops.
• You can skip a frequency when the search stops.
After the search skip frequency is set, the scan-
ner starts direct search again.

Direct Entry Search Hold Mode

To stop searching during direct entry search, press
Hold. Hold appears. In this mode, pressing Func +
changes the search direction downward and
pressing Func +
upward. or appears depending on the search
direction.
Press Func + to decrease the frequency by one
step or Func + to increase it by one step. Hold
down or for about 1 second to quickly
increase or decrease the frequency.
To resume direct search, press Func + Src or Hold.
or appears on the display, showing the search
direction.
or Func + . The scanner
to change the search
changes the search direction
Special Features
44