Hardware Setup - Castlewood 1394/FireWire ORB 2.2 GB Owner's Manual

1.6 HARDWARE SETUP

In this section you will be physically connecting your ORB 2.2GB drive
through a 1394/FireWire converter to your computer system.
Become familiar with your ORB 2.2GB drive and 1394/FireWire converter
Emergency eject hole
Disk insert/eject button
Figure 2
Drive front view
Power LED (Green)
6-pin FireWire
(IEEE1394) port
Figure 4
Converter front view
1. Connect the 1394/FireWire converter to the ORB drive
as shown in Figure 6.
Ensure that the ORB drive is powered off.
2. Connect the ORB drive power supply.
First, attach the round power connector from the power
supply to the ORB drive (center, rear of the drive).
Then, plug the power supply into an AC outlet.
PROBLEM! If the Power/Status LED is not
glowing green or does not light up, refer to
Section 3, Troubleshooting.
CAUTION! The drive should be powered off before
connecting or disconnecting the 1394/FireWire
converter.
Power/Status LED
High density 50-pin
5
SCSI IN
Power supply connector
Figure 3
Drive rear view
SCSI connector
Figure 5
Converter rear view
SCSI OUT
Detach clip
Figure 6
Figure 7