Configuration Options - Castlewood EIDE ORB 2.2 GB Owner's Manual

Now you have located the empty drive bay and mounted your drive
into an adapter, if necessary. You are ready to install the drive into the
computer.
1. Shut down your operating system and power off your computer.
Unplug the AC power.
2. Remove your computer cover.
Refer to your computer manual for the procedure to remove the outer
cover of the computer.
CAUTION: Make sure you keep track of all screws and
fasteners during this process.
3. Prepare the bay for installation.
Make sure the bay is free from any extra screws or plates. Refer to your
computer User’s Manual for more details on this step.
4. The tapping screws are used to secure the adapter bracket containing
the ORB drive in the computer bay.

1.7 CONFIGURATION OPTIONS

Your ORB drive is configured as a slave device when shipped. Please see
your computer User’s Manual for details on the settings used by your system
and what selections to use. There are a few common scenarios listed below.
One of these might match your computer’s system setup. Look into your
computer and identify where the various connectors (there are three
connectors on each cable) of the EIDE/IDE interface cable(s) are attached.
Then refer to the scenario illustrations and descriptions for a match. If you
do find a match, then make note of the possibilities for jumper settings and
cable attachments that are offered. You will need this information to install
your ORB drive.
Desktop and Tower with Primary channel (1), Secondary channel (2),
Figure 6
Hard Drive (3), CD-ROM/DVD Drive (4)
6