Table of Contents
Advertisement
TO WATCH A TV BROADCAST
When
a UHF TV antenna
has been connected to your TV
via the player's ANTENNA terminal, in accordance with the
connection example given in these instructions (page 9},
TV broadcasts can be received normally by proceeding in
one of the following two ways:
@ By switching power of the player off
Before
switching
off power,
press
the STOP/OPEN
button to stop disc playback.
@ By pressing
the TV/LDP
key on
the remote
control, TV mode can be selected.
UHF antenna
|
A
.
CLD-1450
*
To return to disc playback, press the TV/LDP key again.
In either case, the signals from the UHF antenna are fed to
a
oti
A
Press the
ul
ey on the
the TV set via the player.
remote control unit, or turn
off power
NOTE:
(in an area where the TV broadcast signal is weak, slanting stripes
In such cases, or when you wish to watch TV for a long period of
may appear on the TV screen when the TV/LOP key is pressed to
time, we recommend that you turn off the power switch of the
receive a TV broadcast.
This does not always indicate a problem.
player.
The stripes should be eliminated by turning power of the player
off.
ce
When using a TV set with video and audio input jacks
When using the video input jack of your TV, switch to the broadcast using
the controls of your TV.
14
<VRB1022>
Advertisement
Table of Contents
