Explanation Of The Modes - Parkside PLMB 4 A1 Translation Of The Original Instructions

- Measure triple
Pythagoras
- Measure continuous
distance
- Save the last 100
measurements
On switching on, the
device will be in
"Measure distance" mode.
Explanation of the
modes
Measure distance
The current measurement
is always shown in the
bottom line of the display
(2). When the next
measurement is taken, the
previously measured value
slides up one line.
Measure area
Take two measurements.
The individual
measurements are
displayed in the upper
lines. The area is then
calculated from the length
and width and displayed in
the bottom line.
Measure volume
Take three measurements.
The individual measurements
are displayed in small font
in the upper lines.
The volume is then
calculated from the length,
width and height and is
displayed in the bottom line.
Simple Pythagoras/
double Pythagoras/triple
Pythagoras
For calculating the distance
in a right-angled triangle.
As soon as you press the
"Laser" button (4) to take
the measurement, the
value to be measured
will assist by fl ashing on the
small mode icon.
Measure continuous distance
To record a maximum and
minimum distance with
continuous measurement.
Press the "Laser" button
(4) to record the maximum
distance. Press the "Laser"
button (4) again to record
the minimum distance. As
the complete measurement is
taken, the current distance is
displayed in the bottom line.
Save the last 100
measurements
Press the "Laser" button (4)
to go backwards through
the stored values.
GB IE NI
9