Connect The Computer And Scanner; Installing The Software For Pc Users - UMAX Technologies PowerLook PowerLook III Operation Manual

Connect the Computer and Scanner

Now that the interface card has been installed and all of the settings on the scanner
and card are properly set, you can connect the computer and the scanner. Once this
has been done, the hardware installation will be complete. To connect the scanner
and computer, do the following:
1. Connect the SCSI cable to the interface card.
2. If your SCSI configuration requires the use of the external terminator, attach the
terminator to the scanner.
3. Connect the other end of the SCSI cable to the scanner.
4. Connect the power cord to the scanner.
5. Turn on the scanner power.
6. Turn on your computer power.

Installing the Software for PC Users

Install software in two easy steps, in the following order:
1. Image Application Software.
2. MagicScan
MagicScan is the interface used by application software to control UMAX scanners.
Its advanced controls allow precise adjustments in images even during the initial
scan.
For detailed information on installing the image editing application software, refer to
the Installation section of the Image Editing Application Software User's Guide.
1. Insert UMAX MagicScan CD into your CD-ROM drive.
2. Win95 users - click on the Start button on the taskbar and select the Run
command.
Win3.1 users - choose the Run command from the File menu of Windows Program
Manager.
19