Cleaning And Maintenance - Concept2 RK-4050 Manual

Hide thumbs

Table Of Contents

Table of Contents

Available languages

CAUTION

Prior to first use, we recommend boiling the maximum volume of water in the kettle at least 3 times, then pouring it

out. The kettle is then ready for operation.

The kettle may only be used with the supplied base.

OPERATING INSTRUCTIONS

1. Remove the kettle from the base (7), press the button for opening the lid (4), open

the lid (1), and fill the appliance with cold water within the permitted maximum

only. If the water level in the kettle is under the recommended minimum, the kettle

will keep overheating and turning off prematurely.

Note: Make sure that the lid (1) is closed properly, otherwise the kettle can not turn

off automatically

2. Place the kettle on the base (7); electric contacts will get connected automatically.

Thanks to the central connector design, the kettle can turn around 360° and be put

on the base from any side.

3. Connect the base to the mains.

4. Turn the kettle on by pressing the switch (6).

A control light on the switch (6) signals the kettle is in operation. The kettle lid (1)

must be properly closed when water is being heated.

WARNING!

Do not open the lid during heating or immediately after heating is completed. Hot

steam could scald you!

5. After the boiling point has been reached, the kettle will turn off automatically, and

the operating light will go out. Water heating can be terminated prematurely by

moving the switch (6) to the off position.

6. Remove the kettle from the base (7) and use the hot water.

7. If you want to reheat the water you have just finished boiling, wait for approximately

30 seconds before reactivating the switch (6).

8. The kettle filter captures all potential impurities while pouring water.

Note: It is not a sign of a defect when a small amount of water droplets appear on the

kettle base (7). It is a small amount of condensed steam, which deactivates the kettle

thermostat.