Product Description; Cleaning And Maintenance - Concept2 RK3100 Manual

EN

PRODUCT DESCRIPTION

1 Lid of the kettle
2 Body of the kettle
3 Handle
4 Base with supply cable
5 ON/OFF control button
6 Display
1
2
NOTICE:
Before first use, we recommend boiling the maximum volume of water at least 3 times and pour it out. Afterwards,
the kettle is ready for use.
The kettle may only be used with the supplied base.
36
6
5
3
4
OPERATING INSTRUCTIONS
1. Remove the kettle from the base, remove the lid and fill it with cold water (the water level must be within the
MIN-MAX watermarks inside of the kettle).
2. Place the kettle on the base. The electrical contacts will connect automatically. Thanks to the central connector
design, the kettle can turn around 360° and can be placed on the base from any side.
3. When the button is pressed, the current water temperature is displayed. When you press it again, the display will
flash "100° ", if you do not press anything else the water will boil automatically.
4. When the boiling point is reached, you will be alerted by a 2x audible signal.
5. Setting the desired temperature:
6. Press On/Off, then the current water temperature is displayed. By repeatedly pressing the button, you can set the
desired water temperature to 40°,60°,80°,90° or 100°. When the desired temperature is displayed, the water heating
process starts automatically after 2 seconds.
Note:
• The kettle has the KEEP WARM function - Place the kettle on the base and press the "On/Off. Then press the button
for 2 seconds, the symbol will appear on the display and press the button again to set the desired temperature
to be maintained by the kettle.
• The kettle will maintain the desired temperature for 2h and will always heat the water if the temperature drops 5°
below the desired temperature.
• A few drops of water appearing on the base of the kettle after use is not a sign of a defect. It is a small amount of
condensed water, which deactivates the kettle thermostat.

CLEANING AND MAINTENANCE

Caution!
Before each cleaning of the appliance, unplug the power cord from the electrical outlet! Make sure the appliance has
cooled before handling it!
To clean the surface of the appliance, use only a damp cloth, no detergents or hard objects, as they can damage the
surface of the appliance!
Never clean the appliance under running water, do not rinse it or immerse it in water!
Descaling
During normal use, deposition of impurities from water occurs. Use commercially available descaling agents to clean
them (follow the manufacturer's instructions).
Note: Remove the deposits regularly, approximately once a week, depending on the water hardness and frequency of
use. The deposits significantly reduce the heating capacity and the lifespan of the appliance.
EN
37