I Feel - Mitsubishi Electric MSH-07RV Operating Instructions Manual

I FEEL... AUTO OPERATION
With the "0 {i FEEL...)" auto operation mode,
the optimum room condition can be set automati¬
cally with a one-touch operation.
A MITSUBISHI ELECTRIC
CLOCK
'(0)
F If
II I-1 II I
IU ■ UU
ON/OFF TOO fh TOO ;
■ Wu
WARM 'A' COOL :
©STOP
IJt 9
| 0-0
VANE ©START
o To start operation:
OUKff
HHl Press the ^ button.
When the "0 (I FEEL...)" mode is selected, the air
conditioner is automatically controlled at the optimum
temperature.
To stop operation:
outset
H Press the button.
• If you feel slightly warm:
gjjj Press the @ button to lower the tempera-
"" ture.
One press lowers the temperature by about 1 °C.
o If you feel slightly cool:
§g|j Press the (!) button to raise the tempera-
ture.
One press raises the temperature by about 1°C.
When "0 (I FEEL...)" is not selected, press the
g button until it is set.
Each time the button is pressed, the operation mode is
changed in sequence: 0 (1FEEI—) Q (COOL) 6 (DRY)
-»0 (HEAT)
FAN ©STOP
I # i 10-01
'VANE ©START'
Details of operation
According to the room temperature when the operation starts,
the operation mode is automatically selected COOL, DRY or
HEAT. However, when operation is started again within 2 hours
after it is stopped, the same operation mode before the opera¬
tion is stopped is selected. The operation mode selected first is
not changed even if the room temperature changes. If the op¬
eration mode does not match the room condition, select the ap¬
propriate operation mode by pressing the .WQPI button.
Details of auto operation
Room temperature
when started
About 25°C or higher
About 25°C - 23°C
About 23°C or lower
Operation mode
COOL
DRY
HEAT
Target temperature
(initial state)
About 24°C
Room temperature: N
About 25°C or higher
-»COOL
About 25°C - 23°C
-» DRY
About 23°C or lower
-»HEAT v
MSH-07/09/12RV
Operation
Indicator
COOL: When the room temperature is 2°C higher than the set temperature, the set temperature may not be changed
since the air conditioner is operating to reach the target (set) temperature. In this case, please wait until the
room temperature drops to within 2°C of the set temperature and then operate.
HEAT: When the room temperature is 2°C lower than the set temperature, the set temperature may not be changed
since the air conditioner is operating to reach the target (set) temperature. In this case, please wait until the
room temperature rises to within 2°C of set temperature and then operate.
Details of display on the indoor unit
The operation indicator at the right side of the indoor unit indi- _——-- (\
cates the operation state. £ .1% c
Lighting
-)=>- Blinking
CD Not lighting
MSH-18/24RV
Operation Indicator
0
Lighting
Blinking *
Not lighting
Operation indicator lamp
The following indication does not depend on the shape of lamp.
Operation state
Difference between target
temperature and room temperature
This shows that the air conditioner is operating to reach the
target temperature. Please wait until the target temperature
is obtained.
About 2 °C or more
This shows that the room temperature is approaching the
target temperature.
About 2 °C or less
(In case of outdoor unit MXZ series only)
Please refer to INFORMATION FOR MULTI SYSTEM AIR
CONDITIONER (page 8).*
Except MSH-24RV