Table of Contents
Advertisement
r
\
r
\
12. Connecting the power supply
Plug the lamp cable connector into the
socket on the power supply unit.
Secure
the connector by rotating the lock ring as
far as it goes.
Connect the power cable to the power
connector on the power supply unit.
13. Connecting the ex-control cable
(The ex-control cable is used only when
controlling light intensity via the light
intensity control dial on the microscope
body.)
Plug the ex-control cable connector into
the socket on the rear panel of the
microscope.
Plug the other connector of the ex-control
cable to the CRTL connector socket on
the rear panel of the power supply unit.
14. Installing a 35mm SLR camera
Remove the F mount cap from the front
port.
Align the lens in/out index on the camera
to that on the front port, mount the
camera, then rotate the camera in the
direction of the arrow until it stops with a
click.
(See the figure below.)
Install the cable release (option) by
screwing the thread at its end over the
cable release screw of the camera.
To dismount the camera, press the lens
dismounting button on the camera, and
hold the button depressed while rotating
the camera in the opposite direction of
the arrow until it stops.
Then, gently
dismount the camera.
Note that the F
mount may be damaged if you attempt to
rotate the camera in the direction of the
arrow.
For film loading, photomicrographic
mode selection, etc., refer to the
instruction manual of the 35mm SLR
camera.
Advertisement
Table of Contents
