US Robotics Courier V.Everything 3CP3453 Getting Started Manual page 21

DIP Factory
Switch Setting
8 ON
9 OFF
10 OFF
IMPORTANT: When you power ON or reset the Courier, the
DIP switch settings override the settings you may have made
previously using AT commands.
If you change the DIP switch settings while the Courier is
powered ON, you can avoid powering the Courier off to make
the new settings take effect. Just send the Courier the ATZ
command.
2
For more information, refer to the indicated chapter in the Courier Modems
Command Reference.
Setting Effect
OFF Ignore AT commands (dumb mode)
ON Act on AT commands (smart mode)
OFF Disconnect on +++
ON Don't disconnect on +++
OFF Load the configuration that is stored in
non-volatile memory (NVRAM)*
ON Load the &F0 configuration from
read-only memory (ROM)*
For
More
2
Info
Ch 1
Ch 2
Ch 4
Installing the Courier 2-9